Been while fellas, bringing Black Betty out of storage...

If it's about Power Wagons, all generations, this is where it'll go. This is the original PWR Forum Power Wagon Technical Discussion Section. And this includes everything that doesn’t fit in any one of the other categories related to the truck goes here!
Post Reply
User avatar
jeep_boy02
1000_Posts
1000_Posts
Posts: 1098
Joined: Sat Feb 16, 2013 1:21 pm

Been while fellas, bringing Black Betty out of storage...

Post by jeep_boy02 » Tue Mar 09, 2021 10:40 am

So shes been sitting dormant for 1.5 yrs! I am going to do oil change, tire rotate/balance, and run seafoam through tank at a good ratio(more than 1 oz to a gallon). Anything else I should be sure to do? I am getting a P0457 and P0456, replaced the gas cap, purge valve, and solenoid. Cleared codes and the cap light never went away but the 0456 didnt come back and it felt as if it ran better afterwards, and I gained about 1 MPG. The 0457 CEL came back this morning though. Should I order up a charcoal canister?

Lots of maintenance to be done, gotta find a rambox to replace the bed with and build new bumpers and sliders.

Glad to see this place has grown and even though I'm in small town USA 4 yrs ago I was the only PW, now there are 7! And I seen 3 the first day back around town. We're spreading :cheers: :cheers:
2010 black pearl(PXR) on 35s, bypass harness, gooseneck, CAI, 3" magnaflow catback, bulldog hemi GT.... more to come soon
Top
User avatar
pdavey
500_Posts
500_Posts
Posts: 730
Joined: Sun May 20, 2012 7:43 pm
Location: Richmond, VA

Re: Been while fellas, bringing Black Betty out of storage...

Post by pdavey » Tue Mar 09, 2021 11:17 am

jeep_boy02 wrote:So shes been sitting dormant for 1.5 yrs! I am going to do oil change, tire rotate/balance, and run seafoam through tank at a good ratio(more than 1 oz to a gallon). Anything else I should be sure to do? I am getting a P0457 and P0456, replaced the gas cap, purge valve, and solenoid. Cleared codes and the cap light never went away but the 0456 didnt come back and it felt as if it ran better afterwards, and I gained about 1 MPG. The 0457 CEL came back this morning though. Should I order up a charcoal canister?

Lots of maintenance to be done, gotta find a rambox to replace the bed with and build new bumpers and sliders.

Glad to see this place has grown and even though I'm in small town USA 4 yrs ago I was the only PW, now there are 7! And I seen 3 the first day back around town. We're spreading :cheers: :cheers:
Welcome back!

Sent from my SM-G998U using Tapatalk

2005 Dodge Power Wagon QC Black - "Laramie"
Performance Mods:
  • Comp 260 Camshaft, Upgraded Valve Springs, Forged Push Rods, JBA Shorties, Airaid Cold Air Intake, Gibson Dual Cat Exhast (Side Swept), National Speed Custom Tune
Other Mods:
  • Kenwood KVT-719 w/ Garmin Navigation and Kenwood Rear Camera, JL Stealth Sub
Suspension/Protection Mods:
  • Carli Upper "Bomb Proof" Ball Joints, NAPA Lower Ball Joints, Thuren Adj Track Bar, Thuren Adjusted Fox Damper, T-Style Steering Upgrade, New Power Steering Pump, 2012 Power Steering Motor Upgrade, Thuren King 2.5 Custom Rear Shocks -Stage 1, Thuren Off-set Control Arms, Thuren King 2.5 Custom Front Shocks -Stage 2, 35x12.50x17 Nitto Trail Grappler (previous tires Cooper STT), Carli Front Dif Gard,
Style/Other Mods:
  • KC LightBar Behind Tow Hooks Mount, 2 KC Slim Driving Lights, 2 KC Offroading Lights, Weatherguard Black Steel Truck Box, Winch TPS bypass, Warn Wireless Winch Module
Top
User avatar
jeep_boy02
1000_Posts
1000_Posts
Posts: 1098
Joined: Sat Feb 16, 2013 1:21 pm

Re: Been while fellas, bringing Black Betty out of storage...

Post by jeep_boy02 » Tue Mar 09, 2021 12:27 pm

Go Steelers! You'll like what I have planned for a decal renovation.

Sent from my SM-A015A using Tapatalk

2010 black pearl(PXR) on 35s, bypass harness, gooseneck, CAI, 3" magnaflow catback, bulldog hemi GT.... more to come soon
Top
RustyPW
2000_Posts
2000_Posts
Posts: 5440
Joined: Thu May 24, 2012 4:23 pm
Model Year: 2008
Location: Brownsville Pa.

Re: Been while fellas, bringing Black Betty out of storage...

Post by RustyPW » Tue Mar 09, 2021 8:21 pm

Glad you're back. :rockon:
PWOC #53
2008 POWER WAGON RC

My build thread. http://forum.powerwagonregistry.org/vie ... =13&t=2826 :cash: :cash:

Moab '09, '10, '12, '14.
Rausch Creek - Summer '10, Spring-Fall '11, Spring '12, Summer '13, Summer '14, Summer '15, Summer '16, Summer '17, Summer '18, Summer '20, Summer '22,
AOAA Summer '19.

Russ
NRA - Benefactor, Golden Eagle. :lockedandloaded:
Top
User avatar
jeep_boy02
1000_Posts
1000_Posts
Posts: 1098
Joined: Sat Feb 16, 2013 1:21 pm

Re: Been while fellas, bringing Black Betty out of storage...

Post by jeep_boy02 » Sat Apr 03, 2021 11:28 am

Hit one and a quarter leaving work Friday... another milestone. Still tracing down the P0456 and 0457 EVAP codes. Guessing it's going to be a hose somewhere as I put new cap, valve, solenoid, and PCV on.
Image

Sent from my SM-A015A using Tapatalk

2010 black pearl(PXR) on 35s, bypass harness, gooseneck, CAI, 3" magnaflow catback, bulldog hemi GT.... more to come soon
Top
Post Reply

Return to “Power Wagon Talk”