AAM ball joints.
Posted: Sat Aug 29, 2020 8:50 pm
Are these OE for our trucks? Any feedback on them would be appreciated.
Power Wagon Registry
The place for Power Wagon Owners to Hang.
https://forum.powerwagonregistry.org/
AAM ball joints.
https://forum.powerwagonregistry.org/viewtopic.php?f=2&t=7522
Page 1 of 1
Re: AAM ball joints.
Posted: Sat Aug 29, 2020 11:47 pm
I installed the Carli ball joints about 60,000 miles ago. And they are still tight.
Re: AAM ball joints.
Posted: Fri Sep 04, 2020 12:06 am
I have Dynatrac ball joints in my truck. After about 140k miles I rebuilt them, tops were still tight bottoms were loose. For about $195 you can get the rebuild kit for all four ball joints and do the work without having to remove them from the axle, very pleased with this product.
Re: AAM ball joints.
Posted: Fri Sep 04, 2020 4:54 pm
Where do EMF balljoints fall on the good, better, best rating of possible replacements?
Re: AAM ball joints.
Posted: Fri Sep 04, 2020 10:01 pm
Re: AAM ball joints.
Posted: Wed Sep 09, 2020 8:54 pm
Out of stock everywhere. May have to goo Moog.
Re: AAM ball joints.
Posted: Wed Sep 09, 2020 10:44 pm
Re: AAM ball joints.
Posted: Thu Oct 08, 2020 7:32 pm
Re: AAM ball joints.
Posted: Thu Oct 08, 2020 7:34 pm
Tried all weekend to get the hubs off with no luck. Took it to a local shop and it took them 3 days to get the hubs off. Them suckers were on there. Also put 2 new skf hubs on.
Re: AAM ball joints.
Posted: Thu Oct 08, 2020 8:56 pm
When I replaced my ball joints. I had to use a 7" fiber cut off wheel and cut the studs on the ball joints because I couldn't remove the unit bearings. Once I got the steering knuckle out and on the ground. i used a sledge hammer to knock the unit bearings out. 
Re: AAM ball joints.
Posted: Fri Oct 09, 2020 9:53 am
Are these factory ball joints?? $69 per side seems pretty cheap!ACL123 wrote: ↑Thu Oct 08, 2020 7:32 pmWent with the AAM
https://www.dennysdriveshaft.com/p3269_ ... _2500.html
Re: AAM ball joints.
Posted: Sat Oct 17, 2020 8:40 pm
Not sure if our trucks come with these but its the same company who makes our axles.jj141979 wrote: ↑Fri Oct 09, 2020 9:53 amAre these factory ball joints?? $69 per side seems pretty cheap!ACL123 wrote: ↑Thu Oct 08, 2020 7:32 pmWent with the AAM
https://www.dennysdriveshaft.com/p3269_ ... _2500.html
Re: AAM ball joints.
Posted: Sat Oct 17, 2020 9:57 pm
Why would you replace junk with the same junk?jj141979 wrote: ↑Fri Oct 09, 2020 9:53 amAre these factory ball joints?? $69 per side seems pretty cheap!ACL123 wrote: ↑Thu Oct 08, 2020 7:32 pmWent with the AAM
https://www.dennysdriveshaft.com/p3269_ ... _2500.html