Power Wagon Registry

Hi all. I've got a lead on some factory mopar rock rails for my gen3 that I'd like to buy and install. I've searched and found very little detailed information on installing. Most just mention drilling a dozen or so holes in the frame. ...does anyone have first hand experience or know where detailed instructions might be found? It says they come with all hardware and special tools.

Thanks!

Sent from my SM-G900T using Tapatalk

I haven't seen this topic come up in a long time. Rock rails were a very rare option. Might have been dealer installed even. Think they cost around $800+ . Don't remember if that was installed or just parts. The kit came with some very special bolts and fasteners to mount to frame for one time use. Those became impossible to get at some point. I believe the drilling came with homemade rails and a few aftermarket fabricators trying to make copies and using normal bolts/nuts. Basically a hard and expensive undertaking.

Sorry this isn't any help with your question but I'm sure someone has a better answer. Let's see what they have to say.

Let me see where mine are.

Sent from my XT1254 using Tapatalk

I found somewhere that the special tools required are wire hangers and mounting brackets. Other than that I think it's just measuring and drilling. Thanks pit slave ....anything would be helpful.

Sent from my SM-G900T using Tapatalk

I have my instructions. I can try to upload them here later or send them to you in an e-mail.

That would be great trk4sale! Thank you. Pm sent

Sent from my SM-G900T using Tapatalk

On the way!

Thanks trk4sale. Those are very helpful! If I pick these up, I'll be sure to document all of the steps for future use.

Sent from my SM-G900T using Tapatalk