Discussions including Electrical / Lighting & Accessories / Onboard Air
4 posts • Page 1 of 1
this might be a little complicated. I would like to replace the factory fog lights on my 2013 with 4 2" led pods from blackoak. I would like one of the pods on each side to run as normal with the factory switch(on low beams as intended). On high beams, I would like all 4 pods to be manually activated by switch on the dash. Possible? how would I wire the low beam pods to fire with the switch when they are already wired into the factory switch? thanks
- Retired BLM Rig
- Posts: 710
- Joined: Sun Jan 31, 2016 6:51 pm
- Model Year: 2008
- Location: San Clemente, Ca.
Tee in a diode.
2008 Quad Cab - Stock RTI = 655, curb weight = 6081 lbs. Abel Components Plug & Play Locker Bypass®, Abel Components Nanny Kill Switch®, Trailer Hitch Storage, MOLLE Door Panels, Wilton Hitch Vice, Locking Under Seat Storage Drawer, Smittybilt 2781 Air Compressor, 14K PullPal, Hi-Lift First Responder Jack, 25' Jumper Cable System, Slip Yoke Eliminator in a Can, Evolution vs. God, Share the Umbrella, Make sure you're right with God before you meet him!
- Posts: 2124
- Joined: Tue Feb 09, 2016 8:06 am
- Model Year: 2016
- Location: Central Oregon
T in a diode on the factory side of fog light power source. Use the highs to trigger relayed switched negative to all four pods. Powers for high fogs from keyed power.
Best Year Power Wagon
- Posts: 151
- Joined: Thu Oct 19, 2017 4:32 pm
- Model Year: 2018
- Location: Albuquerque
Baja had some instructions for their led pods to replace the fog lights. Probably similar.
2018 White Rambox, Diamondback HD bed cover, White Knuckle sliders, Carli and Purple Cranium diff guards, masterpull 11mm superline