Page 3 of 4

Re: Another Government Wagon Auction

Posted: Sun May 27, 2018 6:50 pm
by Retired BLM Rig
Here's a 2010 in Albuquerque, NM. It has some door damage on both sides and 90K on the clock.


71QSCI18329007C.jpg

Re: Another Government Wagon Auction

Posted: Sun Jul 15, 2018 9:12 pm
by Retired BLM Rig
Here's a higher milage 2010 in Lewistown, MT. It looks like the winch is MIA, along with one of the wheels.

81QSCI18239007A.jpg

Re: Another Government Wagon Auction

Posted: Sun Jul 15, 2018 11:19 pm
by AceMan
Retired BLM Rig wrote:
Sun Jul 15, 2018 9:12 pm
Here's a higher milage 2010 in Lewistown, MT. It looks like the winch is MIA, along with one of the wheels.


81QSCI18239007A.jpg
Wow, that one has lots of damage, check engine light, check 4wd light, torn driver seat, chipped glass, and more. The highest bid shown is $900, but that hasn't met the reserve. I wonder what how much they expect to get it of it? :jawdrop:

Re: Another Government Wagon Auction

Posted: Sat Jul 21, 2018 11:57 am
by Retired BLM Rig
Finally reached the reserve price this morning and closed at $11,330. :jawdrop:
And so it begins. :cash:

Re: Another Government Wagon Auction

Posted: Sat Jul 21, 2018 12:58 pm
by AceMan
Retired BLM Rig wrote:
Sat Jul 21, 2018 11:57 am
Finally reached the reserve price this morning and closed at $11,330. :jawdrop:
And so it begins. :cash:
Yep!! I wonder if it's cheaper to go this route or just get a used one?

Re: Another Government Wagon Auction

Posted: Sat Jul 21, 2018 2:32 pm
by DamageWagon
This is the cheaper route. It’s what I did with my truck. I think I have $20,000 in my truck and it’s decked out and reliable.

Re: Another Government Wagon Auction

Posted: Sun Jul 22, 2018 1:20 am
by KevinABQ
You had to cut chain link fence off the driveshaft, or was that someone else?

Re: Another Government Wagon Auction

Posted: Sun Jul 22, 2018 3:50 pm
by DamageWagon
Yep, previous owner wrapped a fence round the rear shaft. And the front cardan let go and took out the transfer case. When I bought the truck it had a new front shaft and transfer case and the driveshaft lasted me until I turned it into a two-piece shaft this May in Moab

Re: Another Government Wagon Auction

Posted: Sun Jul 29, 2018 3:17 am
by Retired BLM Rig
A 2013 in Cedar City, UT.
This one comes with a Truck Vault storage system in the bed and a lot of cosmetic flaws. It has 78K on the clock.

81QSCI18246049.jpg

Re: Another Government Wagon Auction

Posted: Sun Aug 26, 2018 12:23 pm
by Retired BLM Rig
Here's a 2011 in Moreno Valley, CA.

81QSCI18272002.jpg
81QSCI18272002A.jpg

Re: Another Government Wagon Auction

Posted: Mon Oct 01, 2018 3:03 pm
by Retired BLM Rig
Here's a couple more chances for someone to get in the game for less :cash: .

2008 in Eldorado Hills, CA.

81QSCI18297001A.JPG
2012 in Carson City, NV.

81QSCI18297021A.JPG

Re: Another Government Wagon Auction

Posted: Fri Nov 02, 2018 1:11 am
by Retired BLM Rig
Here's a 2012 in Sasabe, AZ. that would be good for parts or the DIY'r.

91QSCI19051301.JPG

Sold for $11,410

Re: Another Government Wagon Auction

Posted: Fri Nov 02, 2018 9:00 am
by Bill2014
pfffft who really needs a bumper anyway!

Re: Another Government Wagon Auction

Posted: Fri Nov 02, 2018 1:13 pm
by Low_Sky
Bill2014 wrote:pfffft who really needs a bumper anyway!
Or forward gears?


Sent from my iPhone using Tapatalk

Re: Another Government Wagon Auction

Posted: Fri Nov 02, 2018 2:12 pm
by PWJouster
interested in that center console setup to replace to jumper

Re: Another Government Wagon Auction

Posted: Sun Nov 04, 2018 1:28 am
by Retired BLM Rig
PWJouster wrote:
Fri Nov 02, 2018 2:12 pm
interested in that center console setup to replace to jumper
Here's one that accommodates the transfer case floor shifter.

Re: Another Government Wagon Auction

Posted: Tue Nov 06, 2018 1:41 am
by Retired BLM Rig
A 2014 with Ramboxes in Lake Havasu City, AZ.
I think this is the first 4.5 gen I've seen in a government auction

81QSCI19030029.JPG

Re: Another Government Wagon Auction

Posted: Sun Nov 11, 2018 3:19 am
by Retired BLM Rig
:jawdrop: Sold for $14K :jawdrop:

Re: Another Government Wagon Auction

Posted: Sun Nov 11, 2018 11:13 am
by EasyDoesIt
Retired BLM Rig wrote:
Sun Nov 11, 2018 3:19 am
:jawdrop: Sold for $14K :jawdrop:
Damn, that's cheap. Most the time the 2010s are going for $14k.

Per the text it had the 5.7 not the 6.4.

Re: Another Government Wagon Auction

Posted: Sun Nov 11, 2018 12:40 pm
by Low_Sky
I was going to look up the VIN and see if it was a 4G or 4.5G, but FCA seems to have killed their build sheet generator on all their websites. So much for that. Glad I have mine saved.

Re: Another Government Wagon Auction

Posted: Sun Nov 11, 2018 12:58 pm
by Retired BLM Rig
Low_Sky wrote:
Sun Nov 11, 2018 12:40 pm
I was going to look up the VIN and see if it was a 4G or 4.5G, but FCA seems to have killed their build sheet generator on all their websites. So much for that. Glad I have mine saved.
I did the same thing.
Here it is: https://www.dodge.com/webselfservice/Bu ... TXEG181057
Just change the VIN # at the end of the URL if you want to look up other build sheets.

:patriot:

Re: Another Government Wagon Auction

Posted: Sun Nov 11, 2018 4:24 pm
by Low_Sky
Nice!

5.7L on the build sheet. It’s a 4G control arm truck.

The 4.5G was a rolling change in the 2014 model year.


Sent from my iPhone using Tapatalk

Re: Another Government Wagon Auction

Posted: Sun Nov 11, 2018 5:05 pm
by BoldAdventure
Low_Sky wrote:
Sun Nov 11, 2018 4:24 pm
Nice!

5.7L on the build sheet. It’s a 4G control arm truck.

The 4.5G was a rolling change in the 2014 model year.
That is really interesting. Thought 2013 was suppose to be the last year of the 5.7 Power Wagon's. This might be one of the rare ones, just like the few 2017 Laramie Power Wagons that are out there. Part of the rolling change over. As 2017 is also the year they introduce the new trim lines and new decal packages.

Re: Another Government Wagon Auction

Posted: Mon Nov 12, 2018 12:09 am
by Retired BLM Rig
The build sheet shows 11.5" rear axle and 18 X 8 steel wheels. Also no mention of front and rear locking differentials, disconnecting swaybar or winch. I wonder if this was even a Power Wagon or just an ST that they mounted a winch on from a previous vehicle?
No wonder it sold so cheap!

Re: Another Government Wagon Auction

Posted: Mon Nov 12, 2018 1:21 am
by BoldAdventure
Retired BLM Rig wrote:
Mon Nov 12, 2018 12:09 am
The build sheet shows 11.5" rear axle and 18 X 8 steel wheels. Also no mention of front and rear locking differentials, disconnecting swaybar or winch. I wonder if this was even a Power Wagon or just an ST that they mounted a winch on from a previous vehicle?
No wonder it sold so cheap!
Looking at that build sheet, I think you might be right. Can still do 5.7 in non-Power Wagon 2500. That would make the most logical sense.