4th Gen Frame Rail Width/Height

[EasyDoesIt]

Would someone be willing to measure there Frame Rails for me? I'm building sliders this weekend and need to get hardware ordered.

I would measure mine except i'm not home until Friday and want to order today.

I assume its about 4" wide by about 6" tall and was going to get 6" bolts to account for two 1/2" brackets on either side of the frame.

Need measurements of the frame under the doors where the rock slider legs would mount.

Thanks for any help,
Steve

[olyelr]

Im about 1200 miles away from my truck. Otherwise I would bounce out into the garage and help ya out.

I think you are damn close though. I cant remember what size hardware my WK sliders used.

[DamageWagon]

I’ll grab measurements if I get a chance. The frame along the mid section is generally 2.125” wide I believe. I think 4.5” long 1/2” bolts was what I used when I used two 1/2” sandwich plates and a locknut to mount my prototypes. If you mount at the interface of any frame tubes it’s about 3/8” wider.

[EasyDoesIt]

Thanks guys, I picked up a tape measure and hit a dealership. About 3" wide by just under 8" is what I measured. I'll grab 5" bolts just to be safe. Can always add an extra washer or two if needed.

Thanks again.

[EasyDoesIt]

I’ll grab measurements if I get a chance. The frame along the mid section is generally 2.125” wide I believe. I think 4.5” long 1/2” bolts was what I used when I used two 1/2” sandwich plates and a locknut to mount my prototypes. If you mount at the interface of any frame tubes it’s about 3/8” wider.

Picked up a few 4-1/2" bolts for good measure.

[KevinABQ]

There are detailed frame drawings on the builder site, which is linked from the bottom of the ram trucks home pages.